Gundam

Ta-da.. what a massive box..

The box weighs 10kg. It's heavy.

Size comparison between an MG large box and an HGUC box

It takes the clear #1 spot even against other large boxes! And #1 in price too! ;;

The widest width too..

And the tallest height as well.

Opening the box, it looks something like this..

Once you remove the layers of stacked runners, you'll find the bulk parts gathered at the bottom.
Considering the weight load, there's a separate box at the very bottom.

The bulk parts are wrapped in non-woven fabric like that to prevent damage.

Open up the box at the bottom and it's packed full of bulk parts as well

A small box packed full of various bolts and nuts

Bulk parts wrapped in non-woven fabric..

Here's a collection of bulk parts that aren't attached to runners.
You all know that foot peeking out at the bottom wasn't a mistake, right? ^^;

The bulk parts are molded three-dimensionally almost like resin cast pieces..
But they're not solid — they're hollow inside. If they were solid, they'd be insanely heavy;

The waist is also a single bulk part. You can see some seam lines on it.

Some parts come with threaded nut holes already formed in them like that.

The rifle body is one solid chunk.. the seam lines are pretty bad, aren't they.

The T-shirt included in the first-run limited edition The size doesn't fit -_-;

Dozens of various bolts and nuts.. @_@

Four hefty ball joints that look like they weigh about a kilogram

There's also a weird rubber sheet included. As for what it's for.. heh heh

Whoa! Almost all of the exterior parts have under-gate treatment like that.

Even the dark-colored parts all have under-gates.. under-gates..

Runner shot. They take up such an enormous area that I barely managed to get a photo;

Full runner photo

Runner

Parts